Addressable Ancillaries

555.800.002

Tyco CIM800 Contact Input Module Minerva MX

The CIM800 is a flexible addressable input-monitoring device that fits in the standard ancilliary housings. The CIM800 provides two inputs to current MX panels though this can be implemented as two seperately wired spurs (style B) or as a loop (style A) Both spur and loop input wiring can be configured to monitor normally open or normally closed inputs.

555.800.012

Tyco DIM800 Detector Input Module Minerva MX

The DIM800 is designed to power and monitor a circuit of low voltage conventional detectors and callpoints. The detection circuit is powered from an external 24V d.c supply and is reset by the MX addressable panel. The DIM800 monitors the external 24V d.c. and provides a fault signal if it is lost.

577.800.005

Tyco SNM800 Sounder Notification Module Minerva MX

The SNM800 is a remote addressable sounder circuit output device capable of switching sounder and speaker circuits up to 2A @ 24V d.c. or provide a monitored output facility for other applications. These can be used in addition to the two circuits provided as standard on most MX detection panels.

577.800.006

Tyco DDM800 Fire and Gas Detector Module

The DDM800 – Universal Fire & Gas Detector Module is an MX addressable module designed to monitor and signal alarms from:

557.180.423

TM520 Timer Module

The TM520 provides an output that can be activated based on a delay time. If either the key-switch on the module is activated, or a predefined event within the control panel occurs then a times delay (set between 10 minutes and 21 hours 10 minutes) is started. When the delay reaches zero the TM520 output is activated. The unit sounds an internal buzzer and shows a red LED when the output is active, and shows a yellow LED when the timer is counting down. To provide a warning the delay is nearly over, the red LED and the buzzer will pulse 5 minutes before the end of the delay.